Slag too much oil is too dry , very fine cracks discharge increased from virgin peanut oil press at this time to re-adjust the fuel moisture. Oil is too wet , do not form a pressure diesel can not be separated , if this time is too drain joints , cracks extruded from the oil press machine it should adjust the fuel moisture and juice bar assembly tightness. Low oil feedstock is too wet or too dry, damp moldy grain is not full, excessive impurities. To be re- cleaning of oil , or adjust the fuel moisture. Seam is diesel oil drain plug. Should be removed , and according to the level of oil content , adjust the tightness of virgin strip. Parts wear , replace worn parts. When the cake is too thin or too thick , thick cake should be adjusted or the oil situation . Initial open press, pressing chamber temperature is too low , the mill oilfield equipment the temperature .
Rapeseed shaft is pressed to open the card when the initial feeding too much fried oilseeds available slowly feed mill repeatedly ruled out . Pressing process, the virgin bore off material , because a lot of feeding, virgin oil bore is blocked . Therefore , feeding should be continuous and uniform , once the blockage occurs , immediately turn off the power , stop feeding and nesting plate open , exit shaft rapeseed , peanut oil press to clear the breech , re- press .